AMX Modula Instruction Manual page 82

RGBHV+Stereo to CatPro Boards with TXs & RXs
To attach destination device connectors and power to the RX Module:
1.
Fasten the HD-15 cable to the Video Out connector (FIG. 39).
FIG. 39
Attach destination device connectors and power to RX
2. Wire the audio connector (FIG. 39 right shows unbalanced output).
3. Insert the RJ-45 connector into the Cat5 receptacle.
4.
If using the AMX AutoPatch power supply provided – Plug the desktop power supply into the
power jack on the module and into an AC external power source.
Or
If you are providing the power supply – Plug the power cord from a UL (or equivalent) listed power
supply into the power jack on the module. The electrical ratings must meet those indicated in the
specifications table (see page 72).
TX and RX HD-15 Pinouts
FIG. 40
Pinout for HD-15 connector
Note: 55 mA supplied on output pin 9; power draw not to exceed 50 mA per port.
76
HD-15 Audio
Power
RJ-45
Audio wiring
Modula Instruction Manual