AMX Modula Instruction Manual page 186

Appendix E – Vertical Interval Sync (VIS)
3.
Replace or install the VIS board by lining up the board with the board guides that are on the top and
bottom of the expansion board slot. The VIS board has the correct end up when the back of the
connectors are to the right of the board.
FIG. 116
Line up the board with guides and push until flush with the back
4.
Carefully push the board into the enclosure until it snaps into place. Make sure the plate is flush
with the back.
5.
Insert the screws into the holes on the connector assembly and tighten the screws until they are
snug.
FIG. 117
Insert the screws and tighten until snug
6. Cable the VIS board according the steps in the following section.
180
steps 3 through 6
Modula Instruction Manual