AMX Modula Instruction Manual page 140

Cat5 Video and Audio Boards with TXs & RXs
To attach inputs, outputs, and power to the TXs and RXs:
1.
Adjust the RX for cable length if necessary (see page 129).
2.
Attach input and output cables to the TX or RX connectors on the modules or AF-10 boards
(FIG. 89).
TX and RX Modules
Audio
(see FIG. 90
or FIG. 91)
TX and RX AF-10 Boards
RJ-45
S-Video
RCA
(audio)
FIG. 89
Fasten cable onto input or output connector
BNC – Fasten the cable connectors onto the input and output BNC connectors.
RCA – Insert the RCA cable plugs into the input and output RCA jacks.
S-Video – Hold the connector at a slight angle to the right while pushing in or pull back on the
connector housing while pushing the connector in. (AMX AutoPatch S-Video cables lock onto
S-Video connectors. Standard S-Video cables may be used, but will not lock.)
134
Audio
(see FIG. 90
or FIG. 91)
S-Video RJ-45
RJ-45
BNC
Audio
(see FIG. 90
or FIG. 91)
BNC RJ-45
RCA (audio)
Modula Instruction Manual
RJ-45