Attaching Cables - AMX Modula Instruction Manual

Attaching Cables

Important: If using RGBHV/HD-15 boards in a CatPro system – first see "RGBHV+Stereo to CatPro
Boards with TXs and RXs" starting on page 69 for special system information.
When attaching RGBHV/HD-15 input and output cables, refer to the sheet labeled "AutoPatch Modula
Connector Guide" that ships with the system. The sheet shows you where to attach each cable on the rear
of each enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis
1 of 3") on a label located on the left side (near the power receptacle).
To connect RGBHV/HD-15 inputs and outputs:
1.
Fasten the cables onto the input and output HD-15 connectors (FIG. 34).
FIG. 34
Fasten cable onto input or output HD-15 connector
HD-15 Board Connector Pinout
For High Density DB-15 board connector pinout information, see FIG. 35.
FIG. 35
RGBHV/HD-15 input and output board connector pinout
Modula Instruction Manual
RGBHV/HD-15 Board Connector Pinouts
Input (VESA DDC Compliant)
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 V in DDC
5. GND 10. GND
Output
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 V out DDC
5. GND 10. GND
Note: 55 mA supplied on output pin 9; power draw not to exceed 50 mA per port.
RGBHV/HD-15 Boards
11. ID Bit
12. DDC SDA
13. Horizontal sync
14. Vertical sync
15. DDC SCL
11. ID Bit
12. ID Bit
13. Horizontal sync
14. Vertical sync
15. ID Bit
67