Rgbhv+Stereo To Catpro Boards Input/Output Boards Specifications - AMX Optima AVS-OP-1616-110 Instruction Manual

RGBHV+Stereo to CatPro Input/Output Boards
RGBHV+Stereo to CatPro Boards Input/Output Boards
Specifications
RGBHV+Stereo to CatPro board specifications were measured in conjunction with CatPro
RGBHV+Stereo RX Modules using Cat-5e cable (for module specifications, see page 142).
Applies to I/O boards: FG1046-575, FG1046-581.
Also applies to RGBHV+Stereo to CatPro I/O boards contained in pre-configured systems.
Specifications
Maximum Resolution
RGB Crosstalk
RGB Signal to Noise Ratio (SNR)
RGB Input Signal Level Range (max.)
RGB Return Loss
RGB Input Impedance
Sync Input Impedance
Sync Input Polarity
Audio Frequency Response
Audio THD+Noise
Audio Crosstalk
Audio Signal to Noise Ratio (SNR)
Audio Input Level (max.)
Audio Input Impedance
* Signals displayed using a resolution of 1600x1200 at 60 Hz may exhibit slightly visible background noise in
certain circumstances (particularly with LCD monitors).
RGB Output Signal Level Range
(max.)
RGB Output Skew Adjustment
RGB Output Impedance
Sync Output Signal Level
Sync Output Polarity
Audio Output Level (max.)
Audio Output Impedance
Audio Output Volume
Adjustment Range
Signal Types
Connector Types
Supported Cable Types
Note: Skew-free cable is not recommended for use with AMX AutoPatch equipment.
AMX reserves the right to modify its products and their specifications without notice.
134
Parameter
@ 60 Hz up to 1000 ft. (305 m) 1600x1200* (4:3)
f = 5 MHz
f = 30 MHz
Vin = 0.7 V, 100 IRE
f = 5 MHz
Active high or low
20 Hz to 20 kHz
1 kHz, -10 dBu to +4 dBu
1 kHz, Vin = +4 dBu
20 Hz to 20 kHz, Vin = +8 dBu
Active high
or low
Conditions
1920x1080p (16:9)
<-60 dB
<-45 dB
>50 dB
+0.75 V to -0.3 V typical
(terminated)
<-55 dB
75 ohms
2.2 kohms
Output follows input polarity
<±0.3 dB
<0.04%
<-95 dB
>85 dB
+8 dBu
18 kohms
+0.75 V to -0.3 V typical (terminated, user adjustable
with gain and peak using CatPro RX)
0 to 62 ns, in 2 ns increments on R, G, and B channels
(user adjustable using CatPro RX)
75 ohms
Low = 0 V, High = +5 V (unterminated)
Output follows input polarity
+8 dBu
<5 ohm
Mute to +6 dB (user adjustable at CatPro RX)
Input: RGBHV+Stereo Audio (balanced or unbalanced)
Output: CatPro RGBHV+Stereo Audio (unbalanced)
Input: HD-15 & pluggable 5-position terminal block
Output: Female RJ-45
Category cable 5, 5e, 6, 6e, and STP
Value
Optima Instruction Manual