Table of Contents
Advertisement
HV Sync Boards Specifications
Applies to Modula HV sync boards FG1034-464, FG1034-479, FG1034-499, FG1034-502,
FG1034-653, and FG1034-662.
Also applies to these HV sync boards when contained in pre-engineered systems.
Specifications
HV Sync Input Level
HV Sync Output Level
Sync Polarity
Connector Type
AMX reserves the right to modify its products and their specifications without notice.
Attaching Cables
When attaching HV sync input and output cables, refer to the sheet labeled "AutoPatch Modula
Connector Guide" that ships with the system. The sheet shows you where to attach each cable and each
wire on the rear of each enclosure. Follow the sheet exactly; the system was programmed at the factory
to operate only as indicated on the sheet.
To connect HV sync inputs and outputs:
1.
Fasten the cable connector onto the input or output BNC connectors (FIG. 29).
FIG. 29
Fasten cable onto input or output BNC connector
Make sure the video cable is connected to the correct BNC connector on the correct enclosure. HV sync
boards look similar to standard video, wideband, HD-SDI digital, SD-SDI digital, and vertical interval
sync boards, but the "Connector Guide" identifies them.
Modula Instruction Manual
Parameter
Conditions
0 V to +5 V
0 V to +5 V
Output follows Input
BNC
HV Sync Video Boards
Value
57
Hide quick links:
Advertisement
Table of Contents
