System Setup - AMX Modula Instruction Manual

Cat5 Video and Audio Boards with TXs & RXs

System Setup

In a Modula Cat5 Video and Audio system, the Modula's Cat5 boards work in conjunction
with Cat5 S-Video+Stereo TX and RX Modules (or AF-10 boards). Set up the system with a TX module
between each source device and the Modula and an RX module between the Modula and each
destination device (FIG. 81). The Modula input board or the RX (module or AF-10 board) may need
adjustments to compensate for differences in Cat5 cable length. These adjustments must be made before
attaching cables.
Modula
Cat5 TX Module
FIG. 81
Cat5 system setup with TX and RX (modules shown)
Note: The "Y/c - Stereo" versions of the Cat5 Transmitter and Receiver may also be used to convert
two composite and/or two mono audio signals instead of Y/c and stereo.
When installing a Modula system containing Cat5 input boards to route signals to standard output boards
(standard video, S-Video, mono audio or stereo audio), you will need to place a Cat5 TX Module
(or AF-10 board) between each source and the enclosure (FIG. 82).
Modula
Cat5 TX Module
Source Device
FIG. 82
Cat5 system setup with TX (module shown)
128
To adjust the Modula Cat5 input board for differences in cable length, see the directions on
page 130.
To adjust the RX Module for differences in cable length, see the directions on page 131.
To adjust the RX AF-10 board for differences in cable length, see the directions on page 132.
Cat5 RX Module
Source Device
Destination Device
Destination Devices
Modula Instruction Manual