Timer Configuration Parameters - Qlogic SANbox 5800V Series Interface Manual

14 – Command Reference
Command Listing
NTPClientEnabled
NTPServerAddress
timers
Prompts you in a line-by-line fashion to change the timer configuration parameters
described in
For each parameter, enter a new value or press the Enter key to accept the
current value.
AdminTimeout
InactivityTimeout
14-126
Table 14-35. NTP Server Configuration Parameters (Continued)
Parameter
Table 14-36. To configure all system parameters, omit the keyword.
Table 14-36. Timer Configuration Parameters
Parameter
Description
Enables (True) or disables (False) the Network Time Pro-
tocol (NTP) client on the switch. This client enables the
switch to synchronize its time with an NTP server. This
feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is
required and you must first set an initial time and date on
the switch. The synchronized time becomes effective
immediately. The default is False.
The IP address (version 4 or 6) or DNS host name of the
NTP server from which the NTP client acquires the time
and date. The default is 10.0.0.254.
Description
Amount of time in minutes the switch waits before termi-
nating an idle Admin session. Zero (0) disables the time
out threshold. The default is 30, the maximum is 1440.
Amount of time in minutes the switch waits before termi-
nating an idle Telnet command line interface session.
Zero (0) disables the time out threshold. The default is 0,
the maximum is 1440.
S
59263-02 A