Qlogic SANbox 5800V Series Interface Manual page 336

14 – Command Reference
Command Listing
Information Type
MediaPartNumber
MediaRevision
MediaSerialNumber
MediaSpeeds
Temp
Voltage
Tx Bias
Tx Power
Rx Power
Value
Status
HighAlarm
HighWarning
LowWarning
LowAlarm
14-156
Table 14-39. Transceiver Information (Continued)
Vendor media part number
Vender media revision level
Vendor media serial number
Transmission speed capabilities
Temperature in degrees Celsius.
Supply voltage in Volts. The range is 0–6.55.
Transmitter laster bias current in milliamps. The range is
0–655.
Transmitter coupled output power in milliWatts. The range is
0–6.55.
Received optical power in milliWatts. The range is 0–6.55.
Measured value.
State associated with the measured value:
Normal: Value is in the normal operating range.
HighAlarm: Value exceeds the high alarm threshold.
HighWarning: Value exceeds the high warning threshold.
LowWarning: Value is less than the low warning threshold.
LowAlarm: Value is less than the low alarm threshold.
Vendor specified threshold above which an alarm is issued.
Vendor specified threshold above which a warning is issued.
Vendor specified threshold below which a warning is issued.
Vendor specified threshold below which an alarm is issued.
Description
S
59263-02 A