Qlogic SANbox 5800V Series Interface Manual page 332

14 – Command Reference
Command Listing
level
Displays the severity settings for event logging and the setting for the display
level.
options
Displays the options that are available for configuring event logging and automatic
display to the screen. Refer to the
information about how to configure event logging and display level.
port
Displays the ports being monitored for events. If an event occurs that is of the
defined level and on a defined component, but is not on a defined port, no entry is
made in the log.
settings
Displays the current filter settings for component, severity level, port, and display
level. This command is equivalent to executing the following commands
separately: Show Log Component, Show Log Level, and Show Log Port.
Examples
The following is an example of the Show Log Component command:
SANbox #> show log component
Current settings for log
------------------------
FilterComponent
The following is an example of the Show Log Level command:
SANbox #> show log level
Current settings for log
------------------------
FilterLevel
DisplayLevel
The following is an example of the Show Log Options command:
SANbox #> show log options
Allowed options for log
-----------------------
FilterComponent All,None,NameServer,MgmtServer,Zoning,Switch,Port,Eport,Snmp,CLI,Qfs
FilterLevel Critical,Warn,Info,None
DisplayLevel Critical,Warn,Info,None
14-152
"Set Log" command on page 14-101
NameServer MgmtServer Zoning Switch Port Eport Snmp
Info
Critical
S
for
59263-02 A