Qlogic SANbox 5800V Series Interface Manual page 250

14 – Command Reference
Command Listing
Notes
The following tables specify the various factory default settings:
Table 14-9
Show Setup Callhome
configuration values.
Table 14-10
Show Config Switch
Table 14-11
Show Config Port
Table 14-12
Show Config Threshold
configuration values.
Table 14-13
Show Config Zoning
Table 14-14
Show Setup Snmp
Table 14-15
Show Setup Radius
Table 14-16
Show Setup Services
values.
Table 14-17
Show Setup System
Table 14-18
Show Config Security
PrimarySMTPServerAddr
PrimarySMTPServerPort
PrimarySMTPServerEnabled
SecondarySMTPServerAddr
SecondarySMTPServerPort
SecondarySMTPServerEnabled
ContactEmailAddress
PhoneNumber
14-70
shows the Call Home service configuration defaults. Enter the
command to display the Call Home service
shows the switch configuration default values. Enter the
command to display switch configuration values.
shows the port configuration default values. Enter the
command to display port configuration values.
shows the port threshold alarm configuration defaults. Enter the
command to display port threshold alarm
shows the zoning configuration defaults. Enter the
command to display zoning configuration values.
shows the SNMP configuration defaults. Enter the
command to display SNMP configuration values.
shows the RADIUS configuration defaults. Enter the
command to display RADIUS configuration values.
shows the switch services configuration defaults. Enter the
command to display switch services configuration
shows the system configuration defaults. Enter the
command to display system configuration values.
shows the security configuration defaults. Enter the
command to display security configuration values.
Table 14-9. Call Home Service Configuration Defaults
Parameters Default
0.0.0.0
25
False
0.0.0.0
25
False
nobody@localhost.localdomain
<undefined>
S
59263-02 A