Configuring The Ethernet Port; Ip Version 4 Configuration - Qlogic SANbox 5800V Series Interface Manual

4 – Network Configuration

Configuring the Ethernet Port

The Show Setup System
configuration, which includes the following:
IP configurations (versions 4 and 6)
DNS server configuration
To display specific information, add the corresponding keyword. For example, to
display IP version 6 configuration information, enter the Show Setup System Ipv6
command:
SANbox #> show setup system ipv6
System Information
------------------
EthIPv6NetworkEnable
EthIPv6NetworkDiscovery
EthIPv6NetworkAddress
EthIPv6GatewayAddress
Configuring the Ethernet Port
Use the
Ethernet port and other network parameters. You can configure all of the following
parameters in one session, or you can configure specific parameters by adding
the corresponding keyword:

IP Version 4 Configuration

IP Version 6 Configuration
DNS Server Configuration
IP Version 4 Configuration
The switch supports IP version 4, which includes the following:
Network discovery method
IP address
Subnet mask
IP gateway address
4-2
command displays the entire switch network
Set Setup System command in an Admin session to configure the
False
Static
2001::1/64
fe80::1
S
59263-02 A