Qlogic SANbox 5800V Series Interface Manual page 308

14 – Command Reference
Command Listing
The following is an example of the Set Setup System Ipv4 command:
SANbox (admin) #> set setup system ipv4
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv4NetworkEnable
EthIPv4NetworkDiscovery Static
EthIPv4NetworkAddress
EthIPv4NetworkMask
EthIPv4GatewayAddress
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv4NetworkEnable
EthIPv4NetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) :
EthIPv4NetworkAddress
EthIPv4NetworkMask
EthIPv4GatewayAddress
Do you want to save and activate this system setup? (y/n): [n]
The following is an example of the Set Setup System Ipv6 command:
SANbox (admin) #> set setup system ipv6
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv6NetworkEnable
EthIPv6Discovery
EthIPv6NetworkAddress
EthIPv6GatewayAddress
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv6NetworkEnable
EthIPv6Discovery
EthIPv6NetworkAddress
EthIPv6GatewayAddress
Do you want to save and activate this system setup? (y/n): [n]
14-128
True
10.20.116.133
255.255.255.0
10.20.116.1
(True / False)
(dot-notated IP Address)
(dot-notated IP Address)
(dot-notated IPv4 Address)
False
Static
<undefined>
<undefined>
(True / False)
(1=Static, 2=Dhcpv6, 3=Ndp)
(IPv6 Address/Mask Length format) :
(IPv6 Address)
S
:
:
:
:
:
:
:
59263-02 A