Qlogic SANbox 5800V Series Interface Manual page 291

A
Examples
The following is an example of the Set Setup Callhome command:
SANbox (admin) #> set setup callhome
A list of attributes with formatting and current values will follow. Enter a new
value or simply press the ENTER key to accept the current value. If you wish to
terminate this process before reaching the end of the list press 'q' or 'Q' and the
ENTER key to do so.
If either the Primary or Secondary SMTP Servers are enabled, the FromEmailAddress
attribute must be configured or the switch will not attempt to deliver messages.
Current Values:
PrimarySMTPServerAddr
PrimarySMTPServerPort
PrimarySMTPServerEnable
SecondarySMTPServerAddr
SecondarySMTPServerPort
SecondarySMTPServerEnable
ContactEmailAddress
PhoneNumber
StreetAddress
FromEmailAddress
ReplyToEmailAddress
ThrottleDupsEnabled
New Value (press ENTER to accept current value, 'q' to quit):
PrimarySMTPServerAddr
PrimarySMTPServerPort
PrimarySMTPServerEnable
SecondarySMTPServerAddr
SecondarySMTPServerPort
SecondarySMTPServerEanble
ContactEmailAddress
PhoneNumber
StreetAddress
FromEmailAddress
ReplyToEmailAddress
ThrottleDupsEnabled
Do you want to save and activate this Callhome setup? (y/n):
59263-02 A
0.0.0.0
25
False
0.0.0.0
25
False
nobody@localhost.localdomain
<undefined>
<undefined>
nobody@localhost.localdomain
nobody@localhost.localdomain
True
(IPv4, IPv6, or hostname)
(decimal value)
(True / False)
(IPv4, IPv6, or hostname)
(decimal value)
(True / False)
(ex: admin@company.com)
(ex: +1-800-123-4567)
(include all address info) :
(ex: bldg3@company.com)
(ex: admin3@company.com)
(True / False)
14 – Command Reference
Command Listing
:
:
:
:
:
:
:
:
:
:
:
14-111