Qlogic SANbox 5800V Series Interface Manual page 310

14 – Command Reference
Command Listing
The following is an example of the Set Setup System Timers command:
SANbox (admin) #> set setup system timers
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
AdminTimeout
InactivityTimeout
New Value (press ENTER to accept current value, 'q' to quit):
AdminTimeout
InactivityTimeout
Do you want to save and activate this system setup? (y/n): [n]
14-130
30
0
(dec value 0-1440 minutes, 0=never) :
(dec value 0-1440 minutes, 0=never) :
S
59263-02 A