Qlogic SANbox 5800V Series Interface Manual page 222

14 – Command Reference
Command Listing
unpack [file]
Installs the firmware file given by [file]. After unpacking the file, a message
appears confirming successful unpacking. The switch must be reset for the new
firmware to take effect.
Notes
To provide consistent performance throughout the fabric, ensure that all switches
are running the same version of firmware.
To install firmware when the management workstation has an FTP server, use the
Image
Examples
The following is an example of the Image Install command:
SANbox #> admin start
SANbox (admin) #> image install
The switch will be reset.
to I/O traffic.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
FTP or TFTP
User Account
IP Address
Source Filename : 7.4.00.xx_epc
About to install image.
Connected to 10.0.0.254 (10.0.0.254).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
14-42
Install command or the
: ftp
: johndoe
: 10.0.0.254
Do you want to continue? [y/n] y
Firmware Install command.
This process will cause a disruption
S
59263-02 A