Qlogic SANbox 5800V Series Interface Manual page 284

14 – Command Reference
Command Listing
restore
Restores and saves the port, component, and level settings to the default values.
save
Saves the log settings for the component, severity level, port, and display level.
These settings remain in effect after a switch reset. The log settings can be
viewed using the
the Set Log Archive command.
start
Starts the logging of events based on the Port, Component, and Level keywords
assigned to the current configuration. The logging continues until you enter the
Set Log Stop command.
stop
Stops logging of events.
Notes
In addition to critical, warn, and informative severity levels, the highest event
severity level is alarm. The alarm level describes events that are disruptive to the
administration or operation of a fabric and require administrator intervention.
Alarms are always logged and always displayed on the screen.
14-104
Show Log Settings command. To export log entries to a file, use
S
59263-02 A