Qlogic SANbox 5800V Series Interface Manual page 249

A
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the
"Set Log" command on page
To reset the switch with a power-on self test, refer to the
page 14-37. To reset the switch without disrupting traffic, refer to the
command on page
NOTE:
system
Resets the system configuration settings to the factory default values as
described in
NOTE:
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain
unchanged. Refer to
parameters.
59263-02 A
14-40.
The following files are deleted from the switch during a switch reset:
Firmware image files that have not been unpacked
Configuration backup files
Support files
Table 14-17.
Because this keyword changes network parameters, the
workstation could lose communication with the switch.
This keyword does not affect installed license keys.
Table 14-13
14-101.
for information about the zoning configuration
14 – Command Reference
Command Listing
"Hardreset" command on
"Hotreset"
14-69