Config - Qlogic SANbox 5800V Series Interface Manual

A

Config

Manages the Fibre Channel configurations on a switch. For information about
setting the port and switch configurations, refer to the
command on page
Authority
Admin session for all keywords except Backup and List
Syntax
config
activate [config_name]
backup export
cancel
copy [config_source] [config_destination]
delete [config_name]
edit [config_name]
export [account_name] [ip_address] [file_name]
import [account_name] [ip_address] [file_name]
list
restore import
save [config_name]
Keywords
activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the
currently active configuration is used. Only one configuration can be active at a
time.
backup export
Creates a file named configdata, which contains the system configuration
information. This keyword does not require an Admin session. Configuration
backup files are deleted from the switch during a power cycle or switch reset.
The optional Export keyword creates the configuration backup file and exports it to
a remote server prompting you for the server, an account name, the server IP
address or DNS host name, destination file name, and a password if the server
requires one.
cancel
Terminates the current configuration edit session without saving changes that
were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the
default configuration.
59263-02 A
14-95.
14 – Command Reference
Command Listing
"Set Config Switch"
14-13