Qlogic SANbox 5800V Series Interface Manual page 294

14 – Command Reference
Command Listing
Examples
The following is an example of the Set Setup Radius Common command:
SANbox (admin) #> set setup radius common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Current Values:
DeviceAuthOrder
UserAuthOrder
TotalServers
New Value (press ENTER to not specify value, 'q' to quit):
DeviceAuthOrder
UserAuthOrder
TotalServers
Do you want to save and activate this radius setup? (y/n): [n]
14-114
Local
Local
1
1=Local, 2=Radius, 3=RadiusLocal :
1=Local, 2=Radius, 3=RadiusLocal :
decimal value, 0-5
S
:
59263-02 A