Show Interface - Qlogic SANbox 5800V Series Interface Manual

A

Show Interface

Displays the status of the active network interfaces.
Authority
None
Syntax
show interface
Examples
The following is an example of the Show Interface command:
SANbox #> show interface
eth0
lo
59263-02 A
Link encap:Ethernet HWaddr 00:C0:DD:00:00:27
inet addr:10.20.116.131
inet6 addr: fd70:c154:c2df:116:2c0:ddff:fe00:27/64 Scope:Global
inet6 addr: fe80::2c0:ddff:fe00:27/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:137168 errors:0 dropped:0 overruns:0 frame:0
TX packets:2194 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:47764214 (45.5 Mb)
Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.255.255.255
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436
RX packets:3887 errors:0 dropped:0 overruns:0 frame:0
TX packets:3887 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:272461 (266.0 Kb)
Bcast:10.20.116.255 Mask:255.255.255.0
MTU:1500 Metric:1
TX bytes:328639 (320.9 Kb)
Metric:1
TX bytes:272461 (266.0 Kb)
14 – Command Reference
Command Listing
14-149