Set Setup Services - Qlogic SANbox 5800V Series Interface Manual

14 – Command Reference
Command Listing

Set Setup Services

Configures services on the switch.
Authority
Admin session
Syntax
set setup services
This command prompts you in a line-by-line fashion to enable or disable switch
services.
parameter, enter a new value or press the Enter key to accept the current value
shown in brackets.
NOTE:
Disabling TelnetEnabled or GUIMgmtEnabled will immediately terminate the
current Telnet or switch management session. Disable services with caution;
it is possible to disable all Ethernet access to the switch.
TelnetEnabled
SSHEnabled
GUIMgmtEnabled
14-116
Table 14-28 describes the switch service parameters. For each
Table 14-28. Switch Services Settings
Entry
Enables (True) or disables (False) the ability to manage the
switch over a Telnet connection. Disabling this service is not
recommended. The default is True.
Enables (True) or disables (False) Secure Shell (SSH) con-
nections to the switch. SSH secures the remote connection to
the switch. To establish a secure remote connection, your
workstation must use an SSH client. The default is False.
The SSH service requires the Fabric Security license key To
purchase a license key, contact your authorized maintenance
provider or authorized reseller.
Enables (True) or disables (False) out-of-band management
of the switch with Enterprise Fabric Suite 2007 and the Appli-
cation Programming Interface. If this service is disabled, the
switch can only be managed inband or through the serial
port. The default is True.
Description
S
59263-02 A