Qlogic SANbox 5800V Series Interface Manual page 302

14 – Command Reference
Command Listing
The following is an example of the Set Setup Snmp Trap command:
SANbox (admin) #> set setup snmp trap 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
Trap1Enabled
Trap1Address
Trap1Port
Trap1Severity
Trap1Version
Trap1Community
New Value (press ENTER to not specify value, 'q' to quit):
Trap1Enabled
Trap1Address
Trap1Port
Trap1Severity
Trap1Version
Trap1Community
Do you want to save and activate this snmp setup? (y/n): [n]
14-122
True
10.20.33.181
5001
info
2
northdakota
(True / False)
(hostname, IPv4, or IPv6 Address) :
(decimal value, 1-65535)
(select a severity level)
1=unknown 6=warning
2=emergency 7=notify
3=alert 8=info
4=critical 9=debug
5=error 10=mark
(1 / 2)
(string, max=32 chars)
S
:
:
:
:
:
59263-02 A