Firmware Install - Qlogic SANbox 5800V Series Interface Manual

A

Firmware Install

Downloads firmware from a remote host to the switch, installs the firmware, then
resets the switch to activate the firmware. This is disruptive. The command
prompts you for the following:
The file transfer protocol (FTP or TFTP)
IP address or DNS host name of the remote host
An account name and password on the remote host (FTP only)
Pathname for the firmware image file
Authority
Admin session
Syntax
firmware install
Examples
The following is an example of the Firmware Install command using FTP:
SANbox #> admin start
SANbox (admin) #> firmware install
The switch will be reset.
to I/O traffic.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
FTP or TFTP
User Account
IP Address
Source Filename : 7.4.00.xx_epc
About to install image.
Connected to 10.0.0.254 (10.0.0.254).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
59263-02 A
This process will cause a disruption
: ftp
: johndoe
: 10.0.0.254
Do you want to continue? [y/n] y
14 – Command Reference
Command Listing
14-27