Qlogic SANbox 5800V Series Interface Manual page 309

A
The following is an example of the Set Setup System Logging command:
SANbox (admin) #> set setup system logging
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
Do you want to save and activate this system setup? (y/n): [n]
The following is an example of the Set Setup System Ntp command:
SANbox (admin) #> set setup system ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
NTPClientEnabled
NTPServerDiscovery
NTPServerAddress
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
NTPClientEnabled
NTPServerDiscovery
NTPServerAddress
Do you want to save and activate this system setup? (y/n): [n]
59263-02 A
True
False
10.0.0.254
(True / False)
(True / False)
(hostname, IPv4, or IPv6 Address) :
False
Static
10.20.10.10
(True / False)
(1=Static, 2=Dhcp, 3=Dhcpv6)
(hostname, IPv4, or IPv6 Address) :
14 – Command Reference
Command Listing
:
:
:
:
14-129