Qlogic SANbox 5800V Series Interface Manual page 35

A
The network discovery method determines how the switch acquires its IP address.
The IP address can come from the IP address that resides on the switch or from a
server. The switch supports network discovery from the following server types:
Bootstrap Protocol (BootP)
Reverse Address Resolution Protocol (RARP)
Dynamic Host Configuration Protocol (DHCP)
To configure the IP version 4 parameters, enter the Set Setup System Ipv4
command:
SANbox (admin) #> set setup system ipv4
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
EthIPv4NetworkEnable
EthIPv4NetworkDiscovery Static
EthIPv4NetworkAddress
EthIPv4NetworkMask
EthIPv4GatewayAddress
New Value (press ENTER to accept current value, 'q' to quit, 'n' for none):
EthIPv4NetworkEnable
EthIPv4NetworkDiscovery (1=Static, 2=Bootp, 3=Dhcp, 4=Rarp) :
EthIPv4NetworkAddress
EthIPv4NetworkMask
EthIPv4GatewayAddress
Do you want to save and activate this system setup? (y/n): [n] y
59263-02 A
True
10.20.116.133
255.255.255.0
10.20.116.1
(True / False)
(dot-notated IP Address)
(dot-notated IP Address)
(dot-notated IPv4 Address)
4 – Network Configuration
Configuring the Ethernet Port
:
: 10:20:30:40
: 255.0.0.0
: 10.20.30.254
4-3