Hitachi XP P9500 User Manual page 364

-pathid AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the dlmcfgmgr utility.
Always make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-device SCSI-device-name
Use this parameter to place online a path connected to the specified SCSI
device.
For SCSI-device-name, specify the value of Device displayed by
executing the view operation as follows:
# /opt/DynamicLinkManager/bin/dlnkmgr view -lu
For details on how to execute the view operation and display the SCSI
device name, see
(To display program information) on page
parameter value can be specified.
Example
-s
Executes the command without displaying the message asking for
confirmation of command execution from the user. Specify this parameter
if you want to skip the response to the confirmation message: for
example, when you want to execute the command in a shell script or
batch file.
Example
6-12
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
To display LU information on page 6-47
The following shows an example of how to place online a path whose
SCSI device name is /dev/sde while confirming command operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -path –device /
dev/sde
KAPL01050-I The currently selected paths will be changed to
the Online status. Is this OK? [y/n]:y
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
Command Reference
Hitachi Dynamic Link Manager User Guide (for Linux(R))
6-28. Leading zeros can be omitted
6-29. Only one case-sensitive
view
in Parameters