Hitachi XP P9500 User Manual page 288

#/dev/sddlmaa2
/dev/sda2
If LVM2 is used in cases other than above, go to step 5. If LVM2 is not
used, go to step 6.
5 When LVM2 is used, edit the /etc/lvm/lvm.conf file so that the LVM2
.
recognizes the SCSI device, not the HDLM device.
Figure 3-43 Example of Editing /etc/lvm/lvm.conf file on page 3-220
examples of editing the /etc/lvm/lvm.conf file.
Comment out the existing filter and types lines, and add the shaded
lines in the figure.
In addition, set md_component_detection to its original value before
installation.
6 Edit the boot loader configuration file for SCSI startup.
.
If you are using SUSE LINUX Enterprise Server 10, check the /boot/
grub/menu.lst file instead of the /etc/grub.conf file.
The detailed procedure is explained in steps 7 to 11.
Separate examples are provided for when the boot loader is LILO, when
the boot loader is GRUB, when the boot loader is ELILO running on an IPF
host, and when LVM2 is used.
Note that option in the example of editing a setting file refers to any
option that might be valid in the user's environment.
¢
3-220
/
/
Figure 3-43 Example of Editing /etc/lvm/lvm.conf file
When the boot loader is LILO
An example of editing the /etc/lilo.conf file (the underlined
section) is shown below.
After modifying the definition, execute /sbin/lilo command to
activate the new setting. You can delete the configuration for
specifying the HDLM device without causing any problems.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
ext2 defaults
ext2 defaults
:
:
1 1
1 1
show