When Using Red Hat Enterprise Linux 5, Or Red Hat Enterprise Linux 6 - Hitachi XP P9500 User Manual

Executing the following command to start the service:
# service ccsd start
# service cman start
# service rgmanager start
When Using Red Hat Enterprise Linux 5, or Red Hat Enterprise Linux
6
To specify settings for RHCM:
1 Stop the service of the RHCM cluster.
.
Stop the RHCM service with the following command if the service is
running:
# service rgmanager stop
# service cman stop
2 Change the SCSI device being used by RHCM to an HDLM device.
.
Edit as shown below if the lower SCSI device (/dev/sda) of the HDLM
device (/dev/sddlmaa) is being used as /dev/raw/raw1.
# ACTION=="add", KERNEL=="sda", RUN+="/bin/raw /dev/raw/raw1 %N"
ACTION=="add", KERNEL=="sddlmaa", RUN+="/bin/raw /dev/raw/raw1
%N"
Comment out KERNEL=="sda" and add KERNEL=="sddlmaa".
3 If you will restart the host, go to step 4. If you will not restart the host,
.
go to step 5.
4 Restart the host to apply the changes made in step 2.
.
Execute the following command to restart the host:
# shutdown -r now
RHCM setup is complete.
5 Execute the following command to apply the changes made in step 2.
.
# /sbin/start_udev
6 Start the cluster service of RHCM.
.
Executing the following command to start the service:
# service cman start
# service rgmanager start
3-182
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))