Related Products When Using Red Hat Enterprise Linux 5; Cluster Software Supported By Hdlm (If An Fc-San Is Used) - Hitachi XP P9500 User Manual

Kernel architecture
EM64T
#
The HP XP series is not supported.
Notes on using HDLM in a BladeSymphony environment
When HDLM is used in a BladeSymphony environment, the following functions
cannot be used:
• HotPlug
• SystemManager linkage
Note that HDLM cannot use the functions provided by ServerConductor/
DeploymentManager other than the following:
• Backup and restoration
• BIOS/firmware updating
For details on the functions provided by ServerConductor/
DeploymentManager, see the manual ServerConductor/DeploymentManager
User's Guide.

Related Products When Using Red Hat Enterprise Linux 5

The following describes related products when Red Hat Enterprise Linux 5 is
used.

Cluster Software Supported by HDLM (If an FC-SAN Is Used)

When you use HDLM in a cluster configuration, you must install the same
version of HDLM on all the nodes that comprise the cluster. If different
versions of HDLM are installed, the cluster system may not operate correctly.
If the HDLM Version and Service Pack Version, which are displayed by
executing the following command, are the same, the versions of HDLM are
the same:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
Table 3-20 Cluster Software Used with Red Hat Enterprise Linux 5 (IA32) on
page 3-37,
5 (IPF) on page
3-36
Kernel
2.6.9-55.EL
2.6.9-78.EL
2.6.9-11.ELsmp
2.6.9-34.ELsmp
2.6.9-55.ELsmp
2.6.9-78.ELsmp
Table 3-21 Cluster Software Used with Red Hat Enterprise Linux
3-39, and Table 3-22 Cluster Software Used with Red Hat
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
HBA Supported storage systems