Volume/Tone Push Button - Datalogic Magellan 8500Xt Product Reference Manual

Deactivation (Tri-color) LED
flashes Red, then Orange,
Deactivation
then returns to Green.
Indicated
a. Additionally, the FRU LED (7-segment display located in the bottom of the optic cavity — visi-
ble through the horizontal scan window) blinks the number '9'. If EAS deactivation fails to initi-
ate, a low, error tone will be sounded, and the FRU LED will display the error code '9' steadily
(without flashing).
b. Ticking sound will stop upon one of the following: 1) Manual EAS Deactivation Push Button is
pressed and released again, 2) EAS timer runs out, or 3) Following a successful EAS tag
deactivation.

Volume/Tone Push Button

NOTE
PRESS
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
A-6
Table 1-2. EAS Indications
HYBRID MODE
The Volume/Tone Push Button also performs multiple functions depend-
ing upon the duration of time it is pressed:
Volume changes made using the Volume/Tone Push Button are lost
when the scanner is powered-down and are reset to the factory default
setting. If you wish to permanently change the volume, use the special
programming labels in
Table 1-3. Volume/Tone Push Button Functions
FUNCTION
Wakes scanner from Sleep
Mode
Increments volume
High frequency beep
, Programming.
Chapter 7
COMMENT
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- A weight change on the scale.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase speaker
volume. When the loudest volume is reached, a
repeated press of the push button cycles volume back
to the lowest setting, then volume increases on subse-
quent press(es). Four volume levels are available.
Magellan
An EAS tag has
been successfully
deactivated.
TM
8500Xt Scanner