Initializing The Transfer Belt Swing Control Data; Adjusting The Tension On The Drive Belt Of The Transfer Belt Motor - Canon CLC5000 Service Manual

CHAPTER 5 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS

2.6.2 Initializing the Transfer Belt Swing Control Data

When the transfer belt is swung, the
swing data is recorded for use during
swinging operation.
You must initialize the transfer belt swing
control data using 'FUNC
E075-RLS' in service mode whenever you
have done the following:
• If you have removed the transfer belt
(including replacement).
• If you have replaced the transfer belt
swing motor.
•
Memo
•
•

2.6.3 Adjusting the Tension on the Drive Belt of the Transfer Belt Motor

1) Make adjustments so that the gap of the
adjusting screw [1] of the transfer belt
motor is 3.5 ±0.3 mm.
5-32
F-MISCp
Check to make sure that
the transfer belt is not in
contact with the end
sensor.
Make sure that the
transfer belt unit is
drawn out. (Insert the
cover switch key to start
service mode; 'E075'
will be indicated, and
the machine will enter
service mode.)
After executing 'E075-
RLS', turn off and then
on the power switch.
COPYRIGHT © 2001 CANON INC.
F05-206-02
2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001
[1]
3.5±0.3mm