E013 - Canon CLC5000 Service Manual

CHAPTER 5 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS

4.1.6 E013

• Check the detail code of 'E013' using 'DISPLAY > JAM/ERR' in service mode.
Waste toner feeding screw
1) Is '0002' indicated?
YES: The waste toner case is full, imposing excess load on the waste
Waste toner feeding motor (M20)
DC controller PCB
2) Set the meter to the 12VDC range. Does the voltage between
YES: Check the wiring; if normal, replace the waste toner feeding motor.
NO:
Waste toner lock detecting switch (SW4)
DC controller PCB
3) Is the voltage between J2223B-4 (+) and J2223B-5 (–) on the DC
NO:
YES: Replace the DC controller PCB.
E013-0002
1) Turn off the power switch.
2) Apply vibration to area A of the waste toner box [1] so that the toner moves from the
rear to the front.
5-112
toner feeding screw. Remove the waste toner as shown under
"F013-0002."
J2226A-5 (+) and J2226A-6 (–) on the DC controller PCB change
from 5 to 0 V when the Start key is pressed after turning off and
then on the power?
Replace the DC controller PCB.
controller PCB 0 V when the waste toner lock detecting switch is
pressed and 5 V when released?
Replace the waste toner lock detecting switch.
COPYRIGHT © 2001 CANON INC.
[1]
F05-401-01
2000 2000 2000 2000
A
CANON CLC5000 REV.0 JAN. 2001