Canon CLC5000 Service Manual page 737

ERROR CODE
E040
Cause The cassette lifter motor is faulty, or the DC controller PCB is faulty.
Description
0001 The error detection circuit on the DC controller PCB has detected
0002 The error detection circuit on the DC controller PCB has detected
Cause • Multifeeder lifter motor (M1; faulty)
• DC controller PCB (faulty)
Description
0101 The upper lifter sensor (PS2) does not turn ON within 6 sec after
0102 The lower lifter sensor (PS3) does not turn ON within 6 sec after
0103 The error detection circuit of the DC controller PCB detects
E041
Cause • Paper deck motor (M8001; faulty)
• Paper deck lifter upper switch (SW8001; faulty)
• Paper deck lifter lower limit switch (SW8002; faulty)
• DC controller PCB (faulty)
Description
0001 The paper deck lifter upper limit switch (SW8001) does not turn
0002 The paper deck lifter lower switch (SW8002) does not turn on
0003 The error detection circuit on the DC controller PCB has detected
E044
Cause The paper width set for the cassette or the multifeeder is wrong, or the
slide resistor is faulty.
Description
0001 Wrong paper width for multifeeder
0002 Wrong paper width for upper cassette
0003 Wrong paper width for lower cassette
E-10
overcurrent in the upper cassette lifter motor drive circuit.
overcurrent in the lower cassette lifter motor drive circuit.
the multifeeder lifter motor (M1) has turned ON.
the multifeeder lifter motor (M1) has turned ON.
overcurrent in the multifeeder lifter drive circuit.
on within 40 sec after the paper deck motor (M8001) has turned
ON.
within 40 sec after the paper deck motor (M8001) has turned ON.
overcurrent in the deck lifter motor drive circuit.
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001