Canon CLC5000 Service Manual page 497

CHAPTER 5 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
Correcting E194-0001/0002
1) Turn off the power switch.
2) Open the front cover.
3) Remove the image position correction CCD unit. (See the descriptions under "Remov-
ing the Image Position Correction CCD Unit" in Service Manual of CLC1000,Chapter
4.)
4) Remove the screw [2], and remove the support plate (front) [1].
5) Remove the screw [4], and remove the shutter [3]. (At this time, take care not to deform
the grounding plate [5]. Take care also not to lose the screw [4]; it is a special screw.)
6) With lint-free paper, dry wipe the top and bottom faces of the shutter [3], top and bot-
tom faces of the support plate (front) [1], and top and bottom faces of the support plate
(rear) [6].
7) Dry wipe the LED [7]. At this time, do not apply excess force on the LED.
8) Install the shutter with a screw. (At this time, take care not to deform the grounding
plate.)
9) Install the support plate (front) with a screw.
5-140
[2]
[1]
[3]
F05-401-12
F05-401-13
COPYRIGHT © 2001 CANON INC.
[5]
[4]
[6]
[7]
2000 2000 2000 2000 CANON CLC5000 REV.0 JAN. 2001