Installing The Da Unit-A1 - Canon CLC5000 Service Manual

CHAPTER 3 INSTALLATION

7 Installing the DA Unit-A1

Be sure to observe the following when installing the DA unit to its host copier:
1. Check to make sure that the copier has properly been installed. Discon
2. Identify the screws by type (length, diameter) and location.
3. Store the settings data of the DA unit to the PC at the service station in
Step
1 Remove the four screws [2], and detach
the face plate [1] from the copier's rear
cover.
2 If a Card Reader-A1 is to be installed,
connect the relay cable [3] (9-pin;
included with the card reader) to the
connector J7 [4] of the DA unit.
3-34
nect all power plugs.
advance. Likewise, store the settings data to the control server.
Work
COPYRIGHT © 2001 CANON INC.
Remarks
[1]
[2]
[2]
[2]
[2]
F03-700-01
[3]
F03-700-02
2000 2000 2000 2000
[4]
CANON CLC5000 REV.0 JAN. 2001