Canon CLC5000 Service Manual page 392

b. Multifeeder
1) Set the paper guide plate of the
multifeeder to A4R (210 mm).
2) Note that the basic setting is indicated
on the CST-AD screen for 'FUNC' in
service mode on the control panel.
3) Select the size for which you want to
register the basic setting.
MF-A4R
4) Note that basic setting 1 has been regis-
tered.
5) Set the paper guide plate of the
multifeeder to A6R (105 mm).
6) Check that the basic setting is indicated
on the CST-AD screen under 'FUNC' in
service mode on the control panel.
7) Select the size for which you want to
register the basic setting.
MF-A6R
8) Note that basic setting 2 has been regis-
tered.
9) Set the paper guide plate of the
multifeeder to A4 (297 mm).
10) The basic setting is indicated on the
CST-AD screen under 'FUNC' in ser-
vice mode on the control panel.
11) Select the size for which you want to
register the basic setting.
MF-A4
12) Note that basic setting 3 has been regis-
tered.
If you have registered basic set-
tings, record the settings on the
service label.
If you have replaced the DC
controller PCB, enter the set-
tings recorded on the service
label using 'DC-CON' under
'FUNC' in service mode.
COPYRIGHT © 2001 CANON INC.
CHAPTER 5 TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
2000 2000 2000 2000
Guide (front)
CANON CLC5000 REV.0 JAN. 2001
Paper (A6R)
Guide (rear)
F05-207-01
105mm
5-35