Mounting The Developing Bias Assembly Protection Member - Canon CLC5000 Service Manual

8.2.3 Mounting the Developing Bias Assembly Protection Member

Step
1 Remove the M4x8 screw used to secure
the power cord base in place.
2 Secure the developing bias protection
member(left side in the illsutration) to the
power cord base using the M4x8mm
screw removed in step1 as shown. Using
the M4x8mm screw used to hold the rear
cover, secure the developing bias
assembly protection member to the rear of
the base plate.
3 Lead the belt through the gap of the belt
retaining member. Before suspending the
machine, apply light tension, and check to
make sure that the belt is in contact with
the top surface of the retaining member at
four points.
COPYRIGHT © 2001 CANON INC.
Work
2000 2000 2000 2000
CHAPTER 3 INSTALLATION
Remarks
screw
F03-802-08
Hole
Developing bias assembly
protection member
F03-802-09
F03-802-10
F03-802-11
CANON CLC5000 REV.0 JAN. 2001
Hole
3-41