Show Pagp - Cisco Catalyst 3750 Metro Command Reference Manual

show pagp

show pagp
Use the show pagp user EXEC command to display Port Aggregation Protocol (PAgP) channel-group
information.
Syntax Description channel-group-number
counters
internal
neighbor
Command Modes User EXEC
Command History Release
12.1(14)AX
Usage Guidelines You can enter any show pagp command to display the active channel-group information. To display the
nonactive information, enter the show pagp command with a channel-group number.
Examples This is an example of output from the show pagp 1 counters command:
Switch> show pagp 1 counters
Port
---------------------------------------------------
Channel group: 1
Gi1/0/1
Gi1/0/1
This is an example of output from the show pagp 1 internal command:
Switch> show pagp 1 internal
Flags:
Timers: H - Hello timer is running.
Channel group 1
Port
Gi1/0/1
Gi1/0/2
This is an example of output from the show pagp 1 neighbor command:
Switch> show pagp 1 neighbor
Catalyst 3750 Metro Switch Command Reference
2-580
show pagp [channel-group-number] {counters | internal | neighbor}
(Optional) Number of the channel group. The range is 1 to 12.
Display traffic information.
Display internal information.
Display neighbor information.
Modification
This command was introduced.
Information
Sent Recv
0 0
0 0
S - Device is sending Slow hello.
A - Device is in Auto mode.
S - Switching timer is running.
Flags State Timers
SC U6/S7 H
SC U6/S7 H
Flags: S - Device is sending Slow hello.
A - Device is in Auto mode.
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
Flush PAgP
Sent Recv Err Pkts
0 0 0
0 0 0
C - Device is in Consistent state.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner
Interval Count
30s 1
30s 1
C - Device is in Consistent state.
P - Device learns on physical port.
PAgP Learning Group
Priority Method Ifindex
128 Any 16
128 Any 16
OL-9645-10