Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual page 280

MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
6 Modifications
Adding to the System
5. Do one of the following:
6. Revise or complete the required planning form(s) according to the
directions shown in
7. If you rearrange modules in the control unit, the numbering plan reverts to
the factory-set 2-digit plan. You must then reprogram the system:
a.
b.
c.
When you have completed modifying existing forms or completing new forms,
program the modification(s) following the instructions in System Programming.
NOTE:
Placing additional modules in the control unit requires a recalculation
of unit loads. For instructions, see Appendix F and the Equipment
and Operations Reference.
If the control unit has an available slot to the right, and the
guidelines permit placement there, proceed to Step 6.
If you must rearrange existing modules to accommodate the
new one, skip to Step 7.
Table 6-2,
Obtain a blank set of planning forms; copy them from Appendix B of
this book or order them using information found in Appendix B of the
Equipment and Operations Reference.
Locate the Equipment List (if available), the local telephone
company line/trunk information list, the floor plan, and the analysis
of the Employee Communications Survey forms. If any of these
materials have been revised, find both the original and revised
versions.
Work through System Planning, beginning with Chapter 2, "Control
Unit Configuration."
Table 6-3, and Table 6-4.
Issue 1
February 1998
Page 6-5