Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual page 166

MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
4 Features
Telephone and Extension Features
Planning Form Instructions
Use Form 6b to identify extensions permitted to perform trunk-to-trunk transfers.
Under the Trunk-to-Trunk Transfer heading on Form 6b, do one of the following:
To block an extension from completing a trunk-to-trunk transfer, check the
No (factory setting) box.
To allow an extension to complete trunk-to-trunk transfers, check Yes.
HotLine
The HotLine feature is available only for single-line telephones and devices
connected to a port on an 008 OPT, 012, or 016 module. A single-line telephone
connected to an MFM cannot use the HotLine feature. This feature enables you to
set up a telephone to dial one specific number once the telephone goes off-hook.
The number that is dialed is the first personal speed dial (code 01) programmed
on the single-line telephone using centralized telephone programming or
extension programming. (Extension programming is only available before the
HotLine feature is activated.)
A HotLine extension can call a private network extension. See Network Reference
for information.
NOTE: NOTE: NOTE:
In Release 6.0 and later systems, after the Hotline extension number has
been assigned, the FRL value for the Hotline extension number should be
set to 6. This ensures that, regardless of the FRL value assigned to the
route(s) in the UDP Routing Table connecting two switches in a private
network, placing a UDP call from switch A directly connected to switch B
using the Hotline feature will not fail due to the FRL.
Planning Form Instructions
On Form 4f specify if this device will use the HotLine Feature. Under the HotLine
heading on Form 4f, do one of the following:
To set the extension to not use the HotLine feature, check the Off (factory
setting) box.
To set the extension to be a HotLine extension, check the On box. Enter
the extension or telephone number that the HotLine extension dials when it
is taken off-hook in the space provided below the On box.
4
Issue 1
February 1998
Page 4-9
4
4