Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual page 203

MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
4 Features
System Features
Recall Timer
This section contains instructions for designating the length of the switchhook
flash sent when Recall is used to disconnect a call and get a new dial tone without
hanging up. The interval of the switchhook flash and how Recall works depends
on the type of telephone being used.
For multiline telephones, the factory setting is 450 ms. If users experience
difficulty with Recall, the interval can be changed to a longer or shorter interval.
The single-line telephone Flash or Recall button transmits a timed switchhook
flash of about half a second.
Planning Form Instructions
Under the Recall Timer heading on Form 8a, check one of the following:
350 ms
450 ms (factory setting)
650 ms
1 sec
Rotary
This section contains instructions for designating whether dialed digits on
rotary-dial lines/trunks are sent one by one as they are dialed or are stored and
sent when dialing is completed.
Planning Form Instructions
Under the Rotary heading on Form 8a, check one of the following:
To store digits and send them when dialing is completed, check the Delay
(factory setting) box.
To send digits out as they are dialed, check the No Delay box.
4
4
Issue 1
February 1998
Page 4-46
4
4