Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual page 178

MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
4 Features
Operator Features
Under the Call Types heading on Form 6a (page 2):
1. In the QCC Operator to Receive Calls column, for each call type, do one of
the following:
NOTE: NOTE: NOTE:
You cannot assign an operator to either Follow Me calls or calls to QCC
operator extensions.
2. In the QCC Queue Priority Level column, write the level for each call type.
Assign a value of 1 (high priority) through 7 (low priority). The factory
setting is 4.
Voice Announce
This section contains instructions to enable a QCC operator to originate Voice
Announce (VA) calls. When enabled, the Call 5 button on the QCC can originate
Voice Announce calls.
NOTE: NOTE: NOTE:
QCCs cannot receive Voice Announce calls.
Planning Form Instructions
Under the Voice Announce heading on Form 6a, do one of the following:
To prevent QCC operators from originating Voice Announce calls, check
the Disable box (factory setting).
To allow QCC operators to originate Voice Announce calls, check the
Enable box.
Direct Station Selector
Use these instructions only if the system has Direct Station Selectors (DSSs)
connected to MLX operator consoles. Otherwise, skip to the next section, "Group
Assigned Features."
This section contains instructions for recording the range of extensions assigned
to the Page buttons, and for renumbering the extensions for Park so that the
extensions fall within the Page button ranges.
If QCC operators are not to receive the call type, write None.
If one or more QCC operators are to receive the call type, write any
combination of the extension number(s). See Form 2a or 5d.
4
4
Issue 1
February 1998
Page 4-21
4