Maximum Number Of Operator Positions - Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual

MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
2 Control Unit Configuration
Numbering the System
Jacks for Additional Operator Positions
Use these instructions only if the system has more than one operator position.
Otherwise, skip to the next section, Extension Jack Pairs for Analog Telephones.
The maximum number of operator positions is shown in Table 2–5.
Table 2-5.
Position
QCC
DLC
DLC
Any combination of operator positions can be assigned as long as no more than
four are QCCs and the total combined number is no more than eight. For
example, a system can have a combination that consists of four QCCs, two MLX
DLCs, and two analog DLCs. The Call Management System (CMS) equipment
connects to analog extension jacks assigned as DLC positions. You must assign
two DLC positions for each CMS (maximum of two) connected to the system on
analog multiline modules.
Planning Form Instructions
NOTE: NOTE: NOTE:
For each CMS connected to the system, you must assign two DLC
positions. These two DLCs do not need to have the default extension
numbers but do need to be on the same module.
1. On the Control Unit Diagram on Form 1, determine which extension jacks
can be used as operator positions by circling the first and fifth extension
jacks on digital or analog modules until you have reached the maximum
number of eight positions.
2. On Form 2a, mark the extension jacks to be used as additional operator
positions.
Do one of the following:
3.

Maximum Number of Operator Positions

Telephone
MLX-20L
MLX-20L
MLX-28D
Analog multiline
telephones
If the system has additional QCCs, proceed to Step 4.
If the system has additional DLCs, skip to Step 5.
2
Maximum
4
8
8
Issue 1
February 1998
Page 2-20
2