Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual page 202

MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
4 Features
System Features
Calls to Unassigned Extensions
This section contains instructions for designating that calls made to unassigned
extension numbers by remote access users or on DID or dial-in tie trunks are
redirected to another extension number, the QCC queue, or a calling group
instead of to the primary operator.
NOTE: NOTE: NOTE:
Network calls to unassigned numbers are not redirected to the unassigned
extension.
!
SecurityAlert:
DID numbers that correspond to pool dial-out codes (or facility access
codes) can be used to avoid toll restriction, leading to toll abuse and/or
fraud. (See Appendix A, "Customer Support Information" for more
information about security.)
Planning Form Instructions
Under the Calls to Unassigned Extensions heading on Form 8a, do one of the
following:
To keep the factory setting, check the Extension box.
To change from the factory-set redirect to the primary operator, check one
of the following:
— To redirect calls to a QCC operator (Hybrid/PBX only), check the
— To redirect calls to another telephone, check the Extension box and
— To redirect calls to a calling group, check the Calling Group box and
QCC queue box and write the extension number in the space
provided (see Form 2a).
write the extension number in the space provided (see Form 2a).
write the calling group extension number in the space provided (see
Form 7d).
4
Issue 1
February 1998
Page 4-45
4