Control Unit Configuration - Lucent Technologies MERLIN LEGEND Release 6.0 System Planning Manual
Communications system
Hide thumbs
Also See for MERLIN LEGEND Release 6.0:
- System programming manual (1114 pages) ,
- Maintenance and troubleshooting manual (496 pages) ,
- Installation manual (337 pages)
Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 6.0
System Planning 555-660-112
2
Control Unit Configuration
Control Unit Configuration
After you have completed the preplanning tasks described in Chapter 1, Before
You Begin, you can plan the control unit configuration. Planning the control unit
configuration consists of the following tasks:
1.
Planning Module Placement. Calculate the systems line/trunk and
extension capacity according to the number of module types; then map out
the placement of the modules on the Control Unit Diagram.
2.
Recording System Operating Conditions. Note the systems type of
programming equipment, mode and language choice, and whether the
Automatic Maintenance Busy feature is to be enabled or disabled.
3.
Numbering the System. Decide the order in which to connect the
telephones and other equipment to the control unit based on the customers
needs and applications. Determine whether the system-assigned
extension numbers are appropriate for the customers business or if they
need to be renumbered.
This chapter contains instructions for completing each of these tasks.
2
Issue 1
February 1998
Page 2-1
2
Advertisement
Table of Contents
Need help?
Do you have a question about the MERLIN LEGEND Release 6.0 and is the answer not in the manual?