Avaya Octel 200 Installation And Maintenance Manual page 394

8-8 Installation and Maintenance Volume
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
5: Ring Through
6: Floppy Disk
Controller
8: VCU Online
10:Disk getting full
01
DATA-1 =
03
00
DATA-2 =
01−06
0a
0b
0c
DATA-3 =
NOT USED
DATA-4 =
NOT USED
11: Disk Initialization
Failure
DATA-1 = REASON:
01 =
02 =
DATA-2 = NOT USED
DATA-3 = NOT USED
DATA-4 = NOT USED
Octel 200/300 S.4.1
Source
TEST LINE 2 Verify that extension numbers in the table
PORT are correct. Could be a problem in PBX
extensions or LIC.
During read or write Clear Hardware Error Table, run TEST
to floppy FLOP 1. Check cables. If errors repeat,
replace CPU.
Online diagnostic tests Replace VCU. Reboot message server. If
error repeats, replace CPU. If problem
continues contact technical support center.
Disk message capacity For DATA-1=03 and DATA-2=00−06, and
is all used up or 11 errors, erase messages or increase hard
getting there. disk capacity. For DATA-2=10 errors, call
your technical support center.
=
ALARM THRESHOLD CONFIGURED IN SYSTEM
PARAMETER 108 REACHED
= DISK FULL OR CANNOT MAKE MESSAGE REDUNDANT
= NO VOICE FILE SLOTS LEFT
= LOGICAL DRIVE ID THAT IS FULL
= PROMPT AREA FULL
= NO DISK WITH SUFFICIENT SPACE AVAILABLE
= SYSTEM RECORDING LIMIT EXCEEDED (ZERO HOUR DRIVES)
VCU could not Contact your technical support center.
successfully initialize
the disk(s). Either no
valid system disk is
present in the system,
or no valid file system
exists on the system
disk.
NO SYSTEM DISK FOUND
NO VALID FILE SYSTEM FOUND
Remedy Priority
2
1
3
3
3
PB60019−01