Avaya Octel 200 Installation And Maintenance Manual page 422

8-36 Installation and Maintenance Volume
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
66. LAN Reported
Hardware Error
(continued)
DATA-2 = ERROR DATA
DATA-3 = ERROR DATA
DATA-4 = ERROR DATA
67 Patching Error
DATA-4 = 01 PARTIAL PATCH DETECTED
02 PATCH AREA ALLOCATION ERROR
Octel 200/300 S.4.1
Source
Problem detected by
the LAN.
05 = SNMP MANAGER HOST NAME CANNOT BE RESOLVED
Possible reasons include:
Manager host name may be bad.
-
Name server IP address may be bad.
-
The Octel 200/300 cannot communicate with the name server.
-
Other — error code in
-
information.
Correct the SNMP manager host name.
REMEDY:
Correct the name server IP address.
-
Configure the SNMP manager IP address.
-
= 1, 2, or 3. This tells us where the error was logged
DATA-2
from. and
DATA-3 DATA-4
information.
06 = BAD_SUBNET
The subnet mask for self is not configured correctly.
Most common reason is that the subnet mask has never been
configured. The subnet mask is configured for SELF only, and the
value configured is shown went the L Loc command is issued.
Get the correct IP address from the LAN administrator
REMEDY:
and reconfigure the message server
07 = DUP_IPADDR — IP ADDRESS CONFLICT.
There is another system with the same IP address in the subnetwork
that includes the message server.
Get the correct IP address from the LAN administrator
REMEDY:
and configure it in the definition of SELF.
Dependent on value in
DATA-4.
Remedy
Dependent on the DATA-1 values as
described below.
and gives more
DATA-2 DATA-3
together give 16 bits of error
Contact your technical support center.
Priority
3
.
3
PB60019−01