Avaya Octel 200 Installation And Maintenance Manual page 338

Hide thumbs Also See for Octel 200:

Table of Contents

Installation and Maintenance Volume

Displaying CDR Type and Status Configuration

The transaction types and status values, both those enabled and disabled, modified by the LOG MF CDR

command can be printed.

To print a single transaction type or all transaction types currently being collected in the CDR log

file, at the @ prompt, enter:

Specify Filters to PRINT:

<"E"nable or "D"isable> <XA string or "ALL"> <ST string or "ALL">

Empty line when done. ESCape to abort.

Enter the filters you want to print.

To print specific information, enter a transaction type and status value at the > prompt.

You can partially specify a transaction type and a status value. When only the first letter (or two) is

entered, all types and values beginning with the letter are displayed. For example, if the status Fxxx

should be displayed for all transaction types that begin with CAL, at the > prompt, enter: E CAL F

Those transaction types beginning with CAL, such as CALATD, CALATT, CALDID, that have a status

beginning with the letter F, such as FLLQ, FLUD, FLND, are printed.

To display all transaction types and all status values that are enabled, at the > prompt, enter:

To print disabled transaction and status types, use the same command, LOG PF CDR. At the >

prompt, use D to indicate that disabled transaction and status types are to be displayed. For example,

to display all disabled transaction and status types, enter the following at the > prompt:

Octel 200/300

Chapters

Table of Contents