Network Diagnostics - Avaya Octel 200 Installation And Maintenance Manual

Network Diagnostics

Use the LIST NETWORK command to allow messages pending for analog locations to be listed. The
diagnostic commands available for networking depend on whether the networking is analog or digital.
Enter LIST NET
Whether listing an analog network location or a domain location, the screen displays the information in
the same format.
Beginning with S3.0, Network Schedule Table information is displayed. The screen display changes to
show the appropriate network delivery schedule information.
@L Net ...
LOCATION FRAME NUMBER: 0000
DELIVERY SCHEDULE : NORSCH
START TIME: 07:00
INTERVAL : 0 Minutes
LAST OUTCALL : MM/DD/YY
DELAY:
ERRORS: 00000
LIMIT:
MESSAGE #
1BB2
LOCATION FRAME
NUMBER
DELIVERY
SCHEDULE
CURRENT
WINDOW
START TIME
END TIME
INTERVAL
LAST OUTCALL
DELAY
ERRORS
LIMIT
PB60019−01
to allow messages pending for analog and domain locations to be listed.
Enter
END TIME : 12:00
08:07
00000 MIN.
00000
Octel internal use only.
Name of the Network Schedule used.
All message delivery windows that are open/active for that location at the current
time.
The start and time for the delivery schedules.
The minimum time a message must wait before an outcall is made.
The date and time of the last outcall.
Shows how many minutes the message server waits before attempting to send
remaining messages after a failure. Its value is set by System Parameter 69 —
NET: REMOTE DELAY BEFORE RETRY (MIN).
For Digital Networking, this field applies only when a particular domain location is
listed.
The number of times a network call or message attempt to this location has failed.
For Digital Networking, this field applies only when a particular domain location is
listed.
Shows how many times the message server retries network calls to this location
before returning the current message to the creator's mailbox. Its value is set by
System Parameter 68 — NET: REMOTE DELIVERY ATTEMPT LIMIT.
For Digital Networking, this field applies only when a particular domain location is
listed.
Maintenance Commands
CURRENT WINDOW :DEFAULT,2,3,4,5
6-23
Octel 200/300 S.4.1